Building Redler / Reddra

Redler consists of:

6 Sprues

12 Caps

1 Medium Wind Up Motor

1 Pilot

1 Sticker Sheet

The build begins with assembling both the head and tail assembly.

The head and tail assembly are placed between the two large halves, which also houses the motor. The main body assembly is held in place by a small clip on the back and a front chest plate.

The wings are assembled by placing both large and smaller wing segments onto an axle and adding a support bar. This setup is held in place via 4 caps.

The wings are connected to the body via the large peg on the left wing fitting into the receiving port on the right wing, and a U shaped clip.

Two small axle pieces are placed inside each large body fender.

Two vented pieces are placed, the smaller behind the neck and the large at the base of the tail. The pilot is then seated.

Both front and rear legs are assembled . Each leg consists of three piece, the main leg support, the claw, and claw guard.

Each of the four legs placed, and held one via one cap per leg.

The unit is now complete and ready to sticker

This has been a Zoid.US production. No image may be used without permission. � 2010 -WIKD