Building Lord "Disco" Gale 

Lord Gale Consists of:

7 Holotec Sprues

3 Universal Blox Sprues

4 Blox Connectors (2 Large and 2 Small)

2 Green Lens Pieces

7 Holotec Blox

1 Pilot

6 Blox Rubber Inserts

1 Sticker Sheet

The build begins with forming the head and lower jaw.

Complete:

Next, the cockpit is assembled.

The pilot is seated.

The wing connection port is created.

The tail is then built.

The dual pointed back spike is formed.

Each wing is fitted with one claw insert.

Each hand spear is assembled.

The left arm is formed from4 pieces and 2 connectors.

Complete.

The right arm is built.

Next, the left hand claw/cannon is assembled.

Complete.

The claw and cannon combo is fitted on the right arm.

The leg consists of two pieces and two rubber inserts.

The left leg is fitted with an upper fender and reinforced by a dual port piece.

The right leg is constructed. 

The main body frame is built with 7 clear Blox, 4 large connectors, one tri plug piece, and 6 smaller Blox dual end connectors.

The main frame is complete.

A chest place is attached to the front of the main frame via two small connectors, and the bottom is secured via one dual pegged orange piece.

Next, the head, cockpit, wing port, back spike, and tail are inserted into the main body.

Complete.

The left arm, wing, and foot are fitted to the body.

Next the right hand side appendages take their places.

The unit is now ready for stickers (I don't sticker any Holotech pieces) and finally display.

This has been a Zoid.US production. No image may be used without permission. � 2010 -WIKD